Fascut 19547, Instruction Manual

Page: 2 / 39

MODEL FRH-850 BENDER
with cutter head option
INTRODUCTION
The FRH-850 is a rotary table type bender. A cutter head can be added as an option. By following
the enclosed instructions and maintenance schedule, your FASCUT machine will provide you with
years of trouble free service.
WARNINGS
DO NOT operate this machine until you have read thoroughly, and understand
completely all instructions, cautions, dangers, and warnings, contained in this
manual. Failure to comply can result in accidents involving fire, electric shock, or
serious personal injury.
****
Maintain and review instruction manual frequently for continuing safe operation
and instructing possible third-party users. Check www.fascut.com for updates.
DO NOT turn machine on before removing the shipping plug on the top of the oil
reservoir and replacing it with the supplied breather cap. To gain access, remove
the six screws that hold on the back panel. This is where you will find the Foot
Pedal control as well.
ALWAYS wear safety glasses when operating and KEEP fingers away from cutting
blades and bending rollers or serious personal injury may result.
FRH-850 with cutter head option
Size (L x W x H)
32” x 20” x 36” 32” x 25” x 36”
Weight 350 pounds 450 pounds
Capacity 1.1 sq.in. of 36 KSI yield steel
.79 sq.in. of 60 KSI yield steel
1” max. width, 2” max. height
Voltage / Amps 110-120 volts @ 14 amps
– 50/60 Hz, single phase
220-240 volts @ 7 amps
– 50/60 Hz, single phase
Power Supply Two stage hydraulic pump driven by a one (1) HP continuous duty electric
motor.
Bend Dies
½”, ¾”, 1”, 1¼”, 1½”, 1¾”, 2”, 3”, 4½”, 6”
Bend Time 2 sec. for 90

or 7 sec. for 90

depending on material