FASTER TM T– Issue 00
61
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: [email protected]
E
N
G
L
I
S
H
-
•
Insert the spiral with large di motor unit in the central slot of the support det. 4.
•
Install the new price and selection plates.
•
Insert the modified drawer and make sure that the connector is plugged in.
•
Programme the new selections at the desired sale price.
NOTE: In the large space selections, the
selection numbers are odd numbers. E.G.: Selections A 1 and A 2 converted to a single
compartment become a single selection A 1.
•
Test the new selections to ensure that they work correctly.
11.8
ACCESS TO THE ELECTRIC PANEL AND REFRIGERATION UNIT
To access the electric panel or the refrigeration unit proceed as follows:
•
Switch off the machine by means of the main switch and pull out the power plug.
•
Open the door.
•
Use a Philips screwdriver to undo the two screws that fasten the product collection pocket to the cabinet.
Remove the pocket.
•
To remove the refrigeration unit, lower the two levers located on the side of the evaporator box, ensure
that the gasket positioned on the top edge of the evaporator box is not attached to its lodging, pull the
special handle. CAUTION: beware of the cables.
Control panel
: When the product collection pocket is removed the entire vending
machine remains energised. Total isolation from the electric power supply is only
obtained when the plug is removed from the external magneto-thermal switch.
Consequently, all operations required by the vending machine without the protection of
the product collection pocket, must only be carried out by qualified personnel who are
aware of the specific hazards which this condition involves.
•
BOTTLE UNLOADING KIT
The bar can be placed in 6 different holes depending on the
type of bottle loaded
CAUTION: the bottle discharge bar must not be used to pull-out
the drawer.
11.9 INSTRUCTIONS FOR REPLACING THE INTERNAL LIGHTING DEVICE
•
Switch off the machine by means of the main switch and disconnect the plug.
•
Open the main door.
•
Remove the cover from the light source.
•
Replace the light source.
•
Carry out the operations in reverse order to reassemble.
