Farr KT5500, Technical Manual

Page: 138 / 165

KT5500 5-
1
/
2
” T
ong
& CLInCHER® B
aCKup
S
ECTIon
C
onTEnTS
7.10
T
ECHnICaL
M
anuaL
H
yDRauLIC
M
oToR
I
nfoRMaTIon
WARNING:
RINEER RECOMMENDS FOLLOWING ALL STANDARD SHOP SAFETY PRACTICES SPECIFICALLY INCLUDING WEARING OF EYE PROTECTION.
1
2
3
4
5
6
7
8
5
1) Remove snap ring
WARNING: Use caution
when removing snap ring.
If released accidentally it
can become an airborne
hazard.
1) Pry out shaft seal plate
with two screw drivers.
2) Remove seal plate o-
ring from groove in bearing
bore.
1) Loosen and remove 8
each 10-32 bolts.
2) Pry off seal plate with
screw driver.
Loosen and remove 8
each 3/8" bolts with 5/16"
socket head wrench.
1) Press shaft out of
bearing box.
2) Proceed to step 9,
disregarding steps 11 & 12
1) Loosen clamp screw in
lock nut.
2) Unscrew lock nut and
remove.
Lift up on the bearing box
to remove from motor.
1) Two of the 3/8" bolt
holes are provided with
jack screw threads.
2) Insert a piece of 1/4"
round stock by 2-1/2" long
into each jack screw hole
3) Screw two 7/16-14 bolts
into the jack screw threads
until the bearing box is free
of the motor.
REMOVAL OF SHAFT SEAL
REMOVAL OF WHEEL MOTOR SEAL
PLATE AND BEARING BOX
DISASSEMBLY OF WHEEL MOTOR
BEARING BOX