Farnell 4CH, User Manual, Page: 30 / 48

Picture 5-39b
Set the selective image parameters (current channel for single window display and cursor place for multi-window
display). You can use the desktop shortcut menu and enter the interface. The image parameters include: Period,
brightness, contrast, saturation, Hue and Gain. You can set different parameters at different time
sections.(shown as picture 5-39a or 5-39b)
5.5.6 PTZ Config:
Enter into [Main menu PTZ Config] to select the channel you desire to control and set PTZ protocol
(Pelco-D or Pelco-P), Baud Rate (1200, 2400, 4800, 9600), Data bit (8, 7, 6, 5), Stop bit (1, 2), Parity Check
(None, Odd, Even, Mark, Space), Address Code and Cruise status respectively. Please note the PTZ device can
be activated only when a channel in connection with the PTZ camera is selected.( Picture 5-40)
Picture 5-40
Picture 5-40a Picture 5-40b picture 5-40c
Open auto cruise function on PTZ setting menu if you want to setup cruise function (system default: on), and set
up cruise channel, cur point and total quantity and stop time etc.
Channel select: select one channel with PTZ camera
Pattern: set up pre-set bit quantity
indicates starting point cruised scan a path. System default point is 01.
: sets the pan path.
Tour
：
allow you go to a specific preset point.
Preset
：
allow you set a set of specific preset points of a PTZ camera.
1. Select a camera you desire to set a preset point;
2. Adjust the camera in a desired direction
3. Click [Set] to set the point as preset point
4. Click [Save] to save the preset point
5. Follow the above step to add one more preset point.