31
GROWSPAN
™
ROUND PRO GREENHOUSES AND SYSTEMS
Revision date: 01.03.19
INSTALL ROLL-UP PANELS
To this point, the main cover should be secured to
the greenhouse and the roll-up side panels should be
positioned along the sides at the base of the frame.
1. Unfold one roll-up panel and evenly stretch the roll-up
panel out along the side of the greenhouse and center
it from end-to-end.
2. Using the double poly latch channel and the wire
spring, secure the top edge of the film in the
lower
channel
.
3. With the top edge secured, spread the free end of the
panel out so that it hangs evenly from the secured
edge.
4. Continue with the Install the
Roll-up Side Assemblies
procedure.
Photo are used for illustration purposes only. Frame shown
may differ from actual frame.
ASSEMBLE THE ROLL-UP SIDE CONDUIT
Gather the Parts:
• Pipe 1.315'' x 75'' swaged 17 GA (#131S0075)
• Pipe 1.315'' x XX'' plain 17 GA (#131P0XX)
• Tek screws (#FA4482B)
The roll-up side conduit assembly is attached to the bottom
of the roll-up side cover material. This assembly runs the
length of the frame and serves as the center pipe that the
roll-up cover wraps around when it is opened to ventilate
the shelter.
This conduit is identical to the purlins that were
assembled and attached to the frame.
NOTE:
The number of pipes used in the roll-up conduit
assembly varies with the length of the greenhouse.
Roll-up conduit assemblies consist of multiple sections of
swaged 1.315" pipe at 75" in length (part #131S075) and
one (1) additional plain 1.315" pipe at a shorter length
(part #131P0XX) determined by the greenhouse, where
XX represents the remaining length required to complete
the roll-up conduit assembly and to reach the end of the
greenhouse.
Complete these steps to assemble the roll-up side conduit.
1. Locate all sections of pipe needed to assemble the
cover conduit.
2. Insert the swaged end of each pipe into the plain end of
another pipe until the conduit is assembled.
3. Secure each pipe joint with a Tek screw.
4. Place the assembled conduit at the base of the side
where the end of the main cover is located.
NOTE:
Apply duct tape over Tek screws to prevent
damage to main cover.
5. Repeat the steps to assemble the remaining cover
conduit.
6. Continue with the procedure that follows to attach the
conduit to the main cover.
