Farmet KOMPAKTOMAT K1000PS, Operating Manual

Page: 31 / 56

Manual
KOMPAKTOMAT K500PS | K600PS | K700PS | K800PS | K1000PS
31
│
56
6. MACHINE TRANSPORT ON ROADS

According to Chapter 5.3.1, the machine must be put into the transport position, i.e. the machine is
folded, the side frames are secured against unfolding and the ball valves of the transport axle are
secured.

Mechanical axle stops must be used for K800PS and K1000PS machines in order to observe the transport
height below 4m.

The machines are equipped with reflective plates in the front and in the rear that outline the exterior
profile. The operator shall keep the plates clean and free from any damage.

The operator must clean the machine of any dirt to prevent the contamination of the roads before
setting off.

The operator must prepare the machine for the transportation so that it meets the valid regulations,
directives and ordinances for road transportation.

The operator is obliged to pay increased attention during transport on roads, due to the transport
dimensions of the machine.

The operator must observe the valid regulations for transport on roads (laws, decrees) after connecting
the machine to the tractor, for reason of a change of the axle load. The driving properties of the set also
change depending on the terrain nature, adapt the manner of driving to these conditions.

The operator is obliged to present the machine certificate of roadworthiness as needed, according to
the valid regulations for road traffic (decree, law) (only in the Czech Republic).

The operator is obliged to secure sufficient outlook during reversing from his position of the tractor
driver. In case of insufficient outlook, the operator is obliged to call a competent and informed person.

It the machine is aggregated behind the tractor with the rear arms of the three-point hitch, the operator
must secure the three-point hitch rear arms of the tractor in the transport position when transporting
the machine on roads, i.e. prevent sudden drop of the arms by the hydraulic shoulder control lever. At
the same time, the arms of the rear TPH of the tractor must be secured against side swinging.

During machine transport on roads, the operator must observe the valid laws and decrees that deal with
this topic and which specify the relationships of the tractor axle load depending on transport speed.

IT IS FORBIDDEN TO TRANSPORT THE MACHINE ON ROUDS WHEN VISIBILITY DISTANCE IS REDUCED!!