RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona M30 Card Printer User Guide (Rev. 1.0)
3-19
Installing Blank Cards into the Card Hopper
The Fargo Persona M30 Printer is capable of printing single load cards and multiple feed
cards (batch mode).
•
To print using single feed, remove all cards from the Card Hopper, leave the Card
Hopper door closed and place a card in the single Feed Card Slot (which can be used
repeatedly).
•
The cards should be loaded with the print side down and (if applicable) the magnetic strip
up and towards the front of the Printer.
To print while using the Batch mode, follow these instructions. See further visual instructions
below and on the next two pages.
Step Procedure
1
Open the Card Hopper Cover.
2
Press the Card Hopper Load Lever down until the Card Tray locks into place.
3
Load up to 100 cards into the Hopper with the print side down.
If using cards with a magnetic strip, the magnetic strip should be loaded with
the strip up and to the front of the Printer. See further visual instructions
below and on the next two pages.
4
Close the Card Hopper Cover to release the Card Tray.
Continued on the next page
This graphic shows how to insert the cards.
