USE AND MAINTENANCE MANUAL - SECTION 4
ELEVAH 40 MOVE / 40 B AERIAL PLATFORM
– Rev. 12_2021
Page 4-23
Function 4 - Maintenance menu
1. From the Supervisor Menu, press “4” and then press the “Power/Enter” key to access the
maintenance function;
Ø
The high-pitched beep and four flashes of the red LED indicate that function 4 has been accessed
correctly.
2. Press the “Power/Enter” key to enable the maintenance alarm;
Ø
The high-pitched beep and the green LED lighting up indicate that the maintenance alarm is
enabled. The alarm will be set to sound after 250 hours of machine operation.
3. To disable the alarm: press the “Power/Enter” key again;
Ø
The high-pitched beep and the red LED lighting up indicate that the maintenance alarm is disabled.
4. Press CE to exit function 4.
Ø
The high-pitched beep accompanied by the green and red LEDs indicates exit from function 4.
6. Choose another function from the Supervisor Menu or press “CE” to exit the Supervisor
Menu.
To reset the maintenance alarm after 250 hours, disable and re-enable the alarm function as
described above.
Exiting the Supervisor Menu
After all the supervisor operations have been carried out on the unit, press the CE key to exit the
Supervisor Menu.
Disconnecting the power supply to the unit will take the unit out of the Supervisor Menu.
NOTE:
Leaving the unit idle for one minute automatically exits the Supervisor Menu.
USER MENU
Normal machine use
1. Enter the two-digit user ID (created by the Supervisor) followed by the personal PIN;
NOTE:
the default user PIN is 1 2 3 4 (this PIN can be changed as described below).
2. Press the “Power/Enter” key.
Ø
The high-pitched beep accompanied by the green LED indicates that the unit is on and
the machine is ready for use.
NOTE:
While the lock is on, the green LED flashes occasionally, indicating that the electronic lock is enabled.
Changing the user PIN
1. Enter the two-digit user ID followed by the personal or default PIN;
2. Press the “Power/Enter” key
Ø
The high-pitched beep and green LED indicate that the unit is on.
3. Press “1” and then press the “Power/Enter” key (within one minute of enabling the user);
Ø
The red LED will flash once.
4. Enter the new 4-8 digit PIN and then press the “Power/Enter” key;
Ø
The green LED will flash once.
5. To confirm, enter the new PIN again and then press the “Power/Enter” key;
Ø
The high-pitched beep accompanied by the green and red LEDs indicate that the new
PIN has been accepted.
6. The new PIN can now be used to access the vehicle.
Locking the machine
The operator can lock the machine as follows:
1. Press the “Power/Enter” key;
2. Disconnect power to the machine.
