USE AND MAINTENANCE MANUAL - SECTION 4
ELEVAH 40 MOVE / 40 B AERIAL PLATFORM
– Rev. 12_2021
Page 4-2
Battery charging procedure
1. Park the machine in a well-ventilated area, near an AC electric socket;
2. Turn the main switch to OFF and remove the key;
3. Connect the battery charger to a correctly installed and earthed socket according to
regulations in force.
Battery charge warning lights
The battery charge warning lights are located on the left side of the machine's cage.
When charging the battery, the orange battery charge LEDs will light up from 20% up to 80%. Then
the 100% green LED will light up to indicate that the charge is complete. If the machine is not
disconnected from the mains, the green LED changes from steady to flashing, which indicates the
standby status of the battery charger.
If, after connecting to the mains, neither the orange nor the green LEDs light up, there could be
something wrong in the connection to the mains or the battery could be faulty; in which case,
immediately report the problem to the manager.
If the orange error LED flashes, the following problems could occur:
Perform the following operations carefully:
ü
Charging must be carried out in a well-ventilated area, where it is forbidden to smoke and use
naked flames;
ü
It is recommended to avoid using any possible source of sparks near charging batteries;
ü
It is recommended to use anti-static clothing;
ü
Do not lift or tilt the batteries;
ü
Do not attempt to start the machine during the recharge.
Orange LED Blinking
Excessive temperature
Check the space between the charger
and the nearby objects
Over current
Remove the battery and check the
charger
Over voltage or low voltage
Remove the battery and ensure that the
battery voltage is 12V or higher
Short circuit
Check if the power socket is shorted
20
%
40
%
60
%
80
%
100
%
Error