USE AND MAINTENANCE MANUAL - SECTION 3
STOCK PICKER E5P100
– Rev. 02_2020
Page 3-4
When travelling on the ground:
ü
Move the machine with caution avoiding sudden manoeuvres;
ü
DO NOT TRANSPORT PERSONS on the base frame of the machine and in any position
other than inside the cage;
ü
Check the structural condition and cleanliness of the surfaces that the machine is used on
(ensure the surface is suitable for the weight of the machine in work conditions).
During ascent and descent:
ü
Comply with the maximum capacity weights allowed in the cage;
ü
Ensure there are no overhead obstacles along the vertical trajectory;
ü
Do not cause dangerous vibrations and/or oscillations that would result in loss of machine
stability and possible overturning.
ATTENTION
THE STOCK PICKER IS FITTED WITH AN AUTOMATIC BASE LEVELLING CHECK SYSTEM.
WHEN THE MACHINE EXCEEDS THE MAXIMUM TILT ALLOWED BY THE MANUFACTURER
(see the technical specifications of the machine), IT EMITS A WARNING SOUND. IN THESE
CONDITIONS, WITH THE CAGE IN STAND-BY POSITION, THE MACHINE CAN STILL MOVE
WHEREAS, WITH CAGE LIFTED, ANY MOVEMENT OTHER THAN CAGE DESCENT IS
PREVENTED.
Prohibition signs:
Prohibition to overload the machine beyond the indicated limits
Prohibition to use the machine as an aerial platform to carry out works at a height
Prohibition to remove or tamper with the machine's stability devices (sensors, ballasts,
etc.)
Prohibition to remove or tamper with the machine's safety and protection devices
Prohibition to climb on or off the cage in places other than the appropriate gate
Prohibition to increase outreach or work height of the machine using additional equipment
(such as ladders)
Prohibition to cause oscillations on the machine so as not to destabilise it
Prohibition to install any additional device that increases the wind load on the machine
(such as warning signs)
Prohibition to come into contact with live electrical conductors
Prohibition to climb on/off the cage when elevated
Prohibition to lift/lower the cage without operator on board
