Faraday 8720, User Manual

Page: 15 / 36

CHAPTER 2 |
DEVICE PROGRAMMING UNIT USER’S MANUAL
PROGRAMMING
11
CABLE P/N 555-133891
WITH ALLIGATOR CLIPS
BOTTOM OF 8720
ORG
BLK
BLK
GRN ORG
RED
RED
ALL CONNECTIONS ARE POWER LIMITED
- EARTH
GND
+
8701
To Program/Test 8701 Devices:
• Insert the programming plug in one end of cable
P/N 555-133891 into the red and black banana
jacks in the cable compartment in the bottom of
the 8720.
• Using the two alligator clip adaptors provided on
the programming plug, connect the other end of
cable P/N 555-133891 to the red and black wires
of the 8701 device.
*
LOCATING TAB
*NOTE:
When programming or testing
1000/15000devices, the prong on
the same side of the programming
plug as the locating tab goes into
the black banana jack.
PROGRAMMING
PLUG
BLACK
BANANA
JACK
• Press ADDRESS. The cursor will appear under the
address number, allowing the user the option to
change the address setting by using the numerical
keypad.
• Press PROGRAM. The 8720 will prompt the user to
insert or connect a device. Once the device is
connected, the 8720 will program the address. If
the detector or device is programmed successfully,
the label printer will print the number of labels
selected at setup and and the 8720 will display the
message PROGRAMMED OK.
8712
LOOP=1 ADDRESS=111
PROGRAMMED OK
<EXIT CHANGE>
• Press EXIT to return to the Main Menu. To change
the current setting of the detector or device, press
firealarmresources.com