Far East Kitchen Solutions
Installation & user operation guide induction cooking
Page 17 of 20
and the motherboard is tight.
4. Replace the output transformer and then detect again.
L or EL
the IGBT fails
1. Check if the IGBT is damaged.
2. Check whether the IGBT and the small board are soldered.
3. Check motherboard drive.
4. Above check failed to solve the problem, Replace the motherboard.
EP
the magnetic
switch cable is
not connected
1. Check whether the connection between the magnetic switch and the
air head of the movement is tight.
2. Check whether the magnetic switch connection line is disconnection.
3 Check if the terminal of the main board magnetic switch is tight.
II)
TABLE TOP INDUCTION APPLIANCE WITH PUSH BUTTON CONTROLS
Flashing
code
Resolution
1
1. Check the vortex fan 24V / 0.4A on the side of the motherboard to the IGBT cooling is
working or not.
2. The air inlet and air holding port of the incense cold grid is blocked
2
1.
Check if the plug of the IGBT sensor is plugged in tightly or damaged.
2. IGBT temperature sensor connected to the motherboard steel whether there is false
welding or virtual.
3
Check whether the IGBT sensor is short-circuited.
5
1. Check if the coil fan DC24V / 0.31A fan is running.
2. Check is the pot magnetic?
3. Check if the air inlet and outlet are blocked
6
1.
Check whether the coil sensor is loose or damaged.
2.
Check whether the coil sensor is connected to the motherboard whether it is loose or not
inserted
7
Check whether the bottom probe is over heat; check whether the fan is running.
8
1. Check magnetic switch gear switch is damaged.
2. Check whether the magnetic switch is connected to the motherboard plug is not broken or
not inserted.
9
1. Check whether the power switch voltage is low or lack of phase.
2. Check the motherboard glass shaft 470K / 1W resistance is damaged.
-
1. Check whether the distance between the coil and the pot is too good, cannot detect the
pot, The distance between the plate and the pan is 10mm-12mm.
2. The motherboard drive is damaged, and the motherboard driver is replaced.
