- 17 -
key to check the sender’s number and message content, next, press Soft2(Reply)key and input
message content, finally, press Soft2(Send) again to reply this message.
Note: while user browses the message numbers, new messages will be marked by “new”; when
user edits message, press # key that to switch input method,e.g. ABC (uppercase English input),
abs (lowercase English input), 123(digit input), Korean (Korean input(if your phone’s firmware
version supports Korean). PY,( if your phone’s firmware version supports Chinese)
Memo function
Press soft3 ( Memo) key in standby, then Soft1(ADD) key, at this time, user can configure the
future date time in terms of Time format, next, press down key to input the memo content, also
can press # to switch input method, down key again to enter into reminder ring tone and down key
at the third time to enter into ring mode. You can press right or left key to select your reminder
ring tone after you enter into reminder ring tone, and select your ring mode by pressing right or
left key after entering into ring mode. There are two ring modes, ring and text. Ring is reminder
you by ring tone, text only show memo content without ring tone reminder. Finally, press
soft2( save) key to save your memo.
Note: if there is memo notice when your phone is in call/off-hook/hands-free/earphone status,
phone does not reminder by ring tone, only shows memo content in screen.
z
Realize
Secondary Dial
by Dialing for only one time.
When you make secondary dial in off-hook/hands-free/earphone or standby pre-input mode, press
button to postpone input, and screen display will show ^. one stands for 2 seconds.
For example, you input 123^45, the phone will send DTMF( 45) 2 seconds after the phone call
1123. 123^^^45 will make phone send DTMF(45) at 6 seconds interval
z
Phonebook prefix function
At standby mode, press phonebook button, user can not only select his needed number to call out
but also he can add prefix to numbers, then call out. It is convenient for user add prefix numbers
that PBX need.
3.10. call pickup
Call pickup is implemented by simulating pickup function of PBX. it’s that, when A calls B, B
rings but no answer, at this moment, C can hook off and input an appointed prefix plus B’s
number, pick up A’s call and talk with A
The following chart shows how to configure an appointed prefix in dial peer to have call pick up
function.
Summary of Contents for FV6030
Page 60: ... 60 ...