Fantic Motor TL 250, Workshop Manual

Page: 116 / 138

116 116
CHAPTER 18
ENGINE
WORKSHOP MANUAL
TL 250
18.5.11 Remove the clutch
Remove the clutch pressure plate after unscrewing the bolts
from the plate two at a time in diagonally opposite positions.
Then remove the clutch push rod and friction plate.
Remove the lock nut and clutch spacer.
Remove the clutch hub, clutch outer, outer guide and clutch
spacer.
Remove the clutch push rod from the central hole in the
mainshaft.
18.5.12 Remove the drive gear, freewheel and starter gear
Remove the drive gear's lock nut and relevant washer.
Remove the freewheel and starter gear.
Remove the starter gear spacer together with the actual gear
when you remove the gear assembly, and be very careful with
the washer.
18.5.13 Remove the oil pump on the right side
Remove the oil pump's intermediate gear and the oil pump
gear assembly circlip. Remove the oil pump intermediate
gear washer, intermediate gear and gear assembly. Remove
the 3 screws from the oil pump cover plate on the right side
and remove the cover plate assembly and the oil pump inner
and outer rotor assembly. On the internal or external side of
the oil pump intermediate gear shaft, there is an oil pump
intermediate gear washer. Be very careful with the circlip,
washer and oil pump assembly you have removed.
18.5.14 Remove the step gear
Remove the circlip from the groove in the step gear shaft and
remove the step gear washer before removing the gear.