Fanimation Torrento FP920 Series, Owner'S Manual

Page: 7 / 14

7
Mounting the Fan Blades
Figure 2
Figure 3
Socket-Head
Screw with Lockwasher
(2 per blade holder)
Blade Holder Cover
Blade Holder Arm
Figure 1
FP920 – TORRENTO ®
2. Lay flat side of blade holder arm on a flat surface with
the inside of the blade holder arm facing up. This is the
side with the threaded posts and pitched foot.
3. Position the (plastic) woven bamboo blade over the
blade holder with the threaded posts showing. Make sure
the bottom edge of the blade is fully seated against the
blade holder arm.
4. Place blade holder cover on top of the blade, positioning
the holes over the threaded posts.
5. With a Phillips head screwdriver provided, thread both
screws into the posts but do not fully tighten.. (Figure 2)
6. Prior to final tightening, position the centerline of the
blade holder with the center of the end of the blade.
7. Tighten both screws to secure the blade. (Figure 2)
8. Attach Blade Holders to the bottom of the Fan Motor
Hub using the ¼–20 x ⅝ ˝ Screws w/Lock washers as
shown in Figure 3.
9. Make sure the screws with lockwashers securing the
Blade Holders to the Fan Motor Hub are tight and that the
Blade Holders are properly seated. (Figure 3)
NOTE: Periodically check Blade Holder hardware and re-
secure if necessary. (See Maintenance, page 8)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
1. Remove and discard the (rubber) motor “stops” by
removing the five screws. (Figure 1)