Fanimation Torrento FP920 Series, Owner'S Manual

Page: 3 / 14

3
Unpacking Instructions
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in
fi nding your place should you be interrupted.
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 11)
1. Check to see that you have received the following
parts:
Control
Housing
Support
Assembly
Blade Holder Arms &
Blade Holder Covers
Support Shaft
Fan Motor Housing
Assembly
Hardware Bag
▲ WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
• Fan Motor Housing
assembly
• Control Housing Support
assembly
• Base assembly
• Cover Base Connection
• Filigree (3)
• Support Shaft
• Blade Holder Arms (5)
• Blade Holder Covers (5)
• Hardware bag(s):
– Eleven ¼-20 x ⅝ ˝ (blade
holder to fan motor hub)
screws with lock washers
– Eleven
3
/
16
-24 x 12mm
(blade to blade holder)
washer-head screws
• Hardware bag (cont’d):
– Five Control Housing Support
screws
– Seven set-screws
– Ten Filigree Mounting screws
with lock washers & locknuts
– Four Filigree Base Mounting
screws with flat washers
– “T” Allen head wrench (2)
– Phillips Screwdriver, 4 ˝
– Three
⅜ ˝
Lag Shields
– Three
⅜ ˝
Lag Bolts with
flat washers
– Chain Coupler
– Chain Fob
– Balance Kit
Base Assembly
NOTE: Blades are not included with this fan. The illustration shown is not to scale or its actual con fi guration may vary.
Filigree
Cover Base
Connection
This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Pedestal Fan
NOTE: Place the parts from the loose parts bags in a
small container to keep them from being lost. If any parts
are missing, contact your local retailer.
Tools Needed for Assembly
• One Phillips head screwdriver
• One ¼
˝ blade screwdriver
• One stepladder
▲ WARNING
Before assembling your floor fan, refer to section on
proper method of wiring your fan (page 4). If you feel
you do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
▲ WARNING
To Reduce The Risk Of Fire Or Electric Shock, Do Not Use
This Fan With Any Solid-State Speed Control Device.
FP920 – TORRENTO ®
NOTE: This Product Intended For Outdoor Use ONLY .
CAUTION
To Reduce the Risk of Personal Injury, this Product Must
be Secured as Described Below.