Fanimation Torrento FP920 Series, Owner'S Manual

Page: 4 / 14

4
Electrical Requirements
How to Assemble Your Pedestal Fan
Figure 1
Figure 2
Cover Base
Connection
2¾ ˝
Support Shaft
Your new Pedestal fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit. Use
Only On
GFCI Protected Receptacles . DO NOT Use An
Extension Cord! The fan base must be securely anchored
and filigree set assembled.
▲ WARNING
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and the
Pedestal fan must be properly grounded as a precaution
against possible electrical shock.
FP920 – TORRENTO ®
CAUTION
To reduce the risk of personal injury, this product must
be SECURED as described on page 8.
CAUTION
To reduce the risk of electric shock, connect ONLY to an
outlet provided with a Ground Fault Circuit Interrupting
device.
1. Prior to assembly, set aside and save the hardware
bag(s) packed in the packing.
2. Assemble the Cover Base Connection onto lower part of
the Support Shaft. (Figure 1)
3. Route the cord attached to (Base Assembly) wire
through the bottom part of the Support Shaft. (Figure 2)
Pull cord through Shaft until wires are completely through
the Shaft.
INSTALLATION NOTE
Cord and wires are to be fed through end of shaft that
has holes located 2¾ ˝ from end of shaft. Figure 2