Fanimation Torrento FP920 Series, Owner'S Manual

Page: 12 / 14

12
Trouble Shooting
Trouble Probable Cause Suggested Remedy
1. FAN WILL NOT START
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan, or loose
switch wire connections in the switch housing.
3. Reversing switch in neutral position.
1. Check main and branch circuit fuses or circuit
breakers.
2. Check line wire connections to fan and switch wire
connections in the switch housings.
CAUTION: Make sure main power is turned off !
3. Make sure reversing switch position is all the way to
one side.
2. FAN SOUNDS NOISY
1. Blades not attached to fan.
2. Loose screws in motor housing.
3. Screws securing fan blade holders to motor hub are
loose.
4. Wire connectors inside housing rattling.
5. Screws holding blades to blade holders are loose.
1. Attach blades to fan before operating.
2. Check to make sure all screws in motor housing are
snug (not over-tight).
3. Check to make sure the screws which attach the fan
blade holders to the motor hub are tight.
4. Check to make sure wire connectors in switch
housing are not rattling against each other or against
the interior wall of the switch housing.
CAUTION: Make sure main power is turned off !
5. Tighten screws securely.
3. FAN WOBBLES
EXCESSIVELY
1. Fan base bolts on the floor is loose.
2. Screws holding the filigree to the support shaft are
loose.
3. Screws securing fan blade holders to fan motor hub
are loose.
4. Blade holders not seated properly.
1. Tighten fan base bolts.
2. Tighten screws holding the filigree to the support
shaft.
3. Check to be sure screws which attach the fan blade
holders to the fan motor hub are tight.
4. Check to be sure the fan blade holders seat firmly
and uniformly to the surface of the fan motor hub. If
holders are seated incorrectly, loosen the screws and
retighten.
5. Balance blades using balance kit provided in
hardware bag.
▲ WARNING
For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan.
FP920 – TORRENTO
®