34
When the update is done the CSL
Elite Wheel Base + will restart
automatically after firmware update is
completely finished as shown on the
right-hand side:
The CSL Elite Wheel Base + switches
off and on automatically followed by
executing the calibration run.
IMPORTANT:
Do not touch the
attached steering wheel while the
CSL Elite Wheel Base + restarts
and performs the initial calibration
run to avoid injuries and/or
miscalibration!
IMPORTANT:
The CSL Elite F1® Set is secured by firmware and by
driver to prevent the installation of wrong firmwares on the CSL Elite F1®
Set! Do not try to force installation of any wrong firmware to the CSL Elite
F1® Set to avoid damages.
IMPORTANT:
After firmware update the center position of the CSL
Elite Wheel Base + has to be manually calibrated again. This is also in-
dicated by the LED display of the steering wheel showing ‘CAL’. This
message will disappear after manual calibration of the wheel center. See
chapter ‘Hotkeys’
‘Wheel center calibration’ for more details.
IMPORTANT:
After firmware update the H-pattern shifter connected
to the CSL Elite Wheel Base +has to be manually calibrated again. See
chapter ‘Hotkeys’
‘Shifter calibration mode’ for more details.
