the others will listen in on the line and only pick up the line if that particular lift phone number is
chosen. Connect the lift phones in parallel and place the lift phone with number 1 at the far end
of the line. View section 6.13 for programming.
Installation of two or more FältCom ECII™ Flex on the same telephone line requires a separate
power supply to the unit. The ECII™ Flex outlet labelled DC is then connected to the lift’s ex-
isting emergency power supply via a special DC/DC converter. If no power supply is available
a separate emergency power source with a built-in battery can be used. Both products are
described in the product catalogue.
A total of nine ECII™ Flex may be connected using the same subscription. Check with the local
telephone line operator how many devices they support on the line. Ordinary telephones, fax
machines, modems or other types of alarm transmitters must not be connected to the same
telephone line because of the risk of disturbing the ECII™ Flex.
Programming and testing
On the back of the ECII™ Flex, there is a keypad used for programming call numbers, function
selection, and testing. All such settings are configured during the installation procedure and,
normally, no subsequent changes are required. It is also possible to remotely program the lift
phone using a standard phone or Windows-based software and a modem. Contact your local
distributor for more information.
The ECII™ Flex is capable of calling 6 alarm receivers or standard telephones with tone se-
lection.
The ECII™ Flex can be programmed to send a test alarm/routine call to a specific test
alarm/routine call receiver at intervals of 1 – 30 days. This alarm tests the lift phone electron-
ics and the telephone line itself. There is one primary and one secondary test receiver availa-
ble.
The ECII™ Flex will answer an incoming call automatically after one ring signal. In this case,
tones are heard in the receiver when the call is connected.
If an emergency power supply is connected, the ECII™ Flex can automatically send an alarm
if the battery voltage is low and needs to be replaced. A special telephone number for the bat-
tery alarm can be programmed.
See section
Programming
for detailed programming instructions.
Remote programming and monitoring
Version 3 of the ECII™ Flex has improved remote programming and remote monitoring.
4.4.1 Trygga Hissen
Trygga Hissen is a remote monitoring service provided by FältCom. The ECII™ Flex and the
GSM Gateway together with FältComs own device management server offers monitor service
in terms of availability and alarm reception. Contact FältCom for more information.
4.4.2 Remote Programming SW
The Flex Programmer SW is available for remote programming of the ECII™ Flex settings. The
Flex Programmer can be used locally using the 122246 Flex Programming Cable connected to
a computer USB. Or remotely using a standard modem (recommended 102181 Modem availa-
ble from FältCom).
In remote programming the Flex Programmer SW can be set to use either modem or DTMF
communication. If the connection to the ECII™ Flex is PSTN (land line) the recommenced set-
ting is modem, this setting will allow faster connection and will enable file download, e.g.
speech files, to the unit. If the ECII™ Flex is connected on a GSM Gateway the recommended
setting is DMTF. This setting has a lower data rate and will not allow file download but has a
more stable connection. For more information please view the Flex Programmer manual.
162187 Manual FältCom ECII™ Flex
Page 8 of 40