the alarm is disconnected by pressing
, END (320, 321, 323)
. No more calls will be made.
Repeat Message 2
If the receiver wants to hear the recorded message 2 once again press
1, REPEAT MESSAGE
2
. The message can be repeated at any time during the call.
Forwarding a call
If you want to forward the alarm to the next alarm receiver, press
2, FORWARD
. The alarm is
then closed, and the ECII™ Flex will call the next programmed alarm receiver. Please note that
the alarm call has to be acknowledged before forwarding the call.
Termination of active alarm mode
If the function active alarm mode is activated and the product is in active alarm mode, i.e.
there has been an alarm and the ECII™ Flex is open for incoming calls, you can close the in-
coming calls window by pressing the key
5,
TERMINATE ALARM MODE
. The call is auto-
matically disconnected.
Speech switching
If the automatic speech switching is not satisfactory, you can change to manual speech switch-
ing
8, SIMPLEX TALK
and
7, SIMPLEX LISTEN
. Revert to automatic speech switching by
pressing
4, ACKNOWLEDGE
.
Calls to a lift phone
7.8.1 Multiple units on the line
If answering function is activated, or if alarm mode function is programmed, and ECII™ Flex
is in active alarm mode, it is possible make a call to the ECII™ Flex from a tone dialling phone
or a mobile phone according to the following:
1.
Dial the number to the lift phone.
2.
After one ring signal the first ECII™ Flex answers and sends a modem (fax) tone. Wait
for the modem tone to stop and listen for a 3-tone message.
3.
Press # and number of the wanted lift phone (1-9). For instance #2 for ECII™ Flex 2 in
the chain. Note that #1 must be pressed by the caller even if only one ECII™ Flex is
mounted. The ECII™ Flex will reply with another 3-tone message indicating the correct
device has answered the call.
4.
Press 4 to activate voice connection.
5.
Press 5 to terminate a possible active alarm mode. The call is then disconnected.
6.
Press 7 to listen in simplex mode.
7.
Press 8 to speak in simplex mode.
8.
Press 3 to activate the speaker and microphone in the Speaker Unit (if connected).
Press 3 again to go back to the ECII™ Flex speaker and microphone.
9.
Press 0 or
to disconnect the call.
7.8.2 Single unit on the line
If the function
142 has been programmed the ECII™ Flex will answer the call and go straight
to conversation mode. The ECII™ Flex will behave differently depending on the acknowledge-
ment settings:
For normal acknowledge (default setting) and
320 go through steps 4 – 8 above.
For acknowledgement functions
321 and
323 the ECII™ Flex will automatically go to duplex
162187 Manual FältCom ECII™ Flex
Page 34 of 40