Falcon RJ-8000, User Manual, Page: 155 / 190

RJ-8000 OPERATION MANUAL 6 Troubleshooting
6-5
(12) Media is damaged during media Initial.
NOTE
Remove the jammed or damaged media, referring to "7.4 Options/Supply list".
(13) Tracing media or other thin media cannot be detected.
8 Check the media for curling or liftoff. Use the recommended media
When using media other than recommended
media , set the following items in the media
setting menu.
•
Media
•
HeadHeight
•
Stiff
4.3.1 Media type
4.4.2 Items in the
setup menu
No. Possible cause Solutions References
1 You did not use recommended media. Use recommended media.
4.3.1 Media type
2 The loading position of the media is not
correct. Load the media correctly.
3.6.2 Loading
roll media
3.6.3 Loading
sheet media
3 You did not load the media straight into the
printer. Load the media straight into the printer.
3.6.2 Loading
roll media
3.6.3 Loading
sheet media
4 Foreign material, such as piece of media, is
attached to the pressurizing roller. Clean the pressurizing roller.
5.3.2 Cleaning
inside the printer
5 You used the printer where air from an air
conditioner blows or other location not
appropriate for the specified environment. Use the printer in the specified environment.
7.2 Product
Specifications
6 You loaded sheet media into the printer. Set the CutSize setting to Length or Width.
4.4.2 Items in the
setup menu
7 You used media folded, creased, damaged,
tore, curled, or inclined to be curled . Replace the media.
4.3.2 Cautions on
handling media
No. Possible cause Solutions References
1 You did not use recommended media. Use recommended media.
4.3.1 Media type
2 You used the printer in direct sunlight or other
locations not appropriate for the specified
environment. Use the printer in the specified environment.
7.2 Product
Specifications
No. Possible cause Solutions References