Falcon Elan 90 Ceramic, User Manual & Installation & Service Instructions

Page: 25 / 32

25 U109655
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Australia
8. To Replace the Grill Controller
Remove the control panel and lift up the hob - see sections 1
and 2. Disconnect the wiring from the controller. Remove the
two screws holding the controller to the mounting panel. Fit
the new controller and reassemble in reverse order. Check for
correct operation.
13. To Replace an Oven Door
Open the oven door and remove the Handyrack (where fitted)
by springing one side out of the bracket on the door and
sliding the other side free. Loosen the two top hinge screws.
The door is heavy, so take care .
Support the weight of the door and remove the screw nearest
the hinge pin. Swing the hinge up and away from the hinge
pin on the door. Lift the door away from the bottom hinge.
Re-assemble in reverse order.
When replacing the door, ensure that the nylon hinge bush
is in position between the hinge pin and the hinge bracket at
the both the bottom and top.
14. To Change the Main Oven Door Latch
Remove the outer door panel (see 'The Main Oven' section
under 'Cleaning your Cooker'). Remove screws ‘B’ holding the
latch assembly to the inner door panel:
Fit the new catch and reassemble in reverse order. Verify that
the door operation is correct.
15. To Adjust the Main Oven Door Catch Keep
Open the oven door, and slacken off the locknut at the base
of the keep:
Screw in or out as required until the required fit is obtained.
Retighten the locking nut.
16. To Replace the Main Oven Door Seal
Open the oven door. The seal is held in place by small hooks
on the rear face. At the corner, pull the seal diagonally away
from the door centre until the hook is released. Proceed to
the next hook and release it in a similar way, and so on.
You can use force if the hooks are stiff, as the old seal will be
discarded.
When fitting the new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of the
door, and proceed around the door, snapping in each hook in
turn.
17. To Replace the Tall Oven Door Outer Panel
Remove the oven door - see section 13. Lay the door face
down on a suitable surface and remove the two screws from
bottom edge of door and the two screws from the inside face
of the door.
Remove the outer door panel. Remove the door handle by
unscrewing the two screws.
Remove the two cross-headed screws holding the door
handle fixing bracket to the door panel. Fit the door handle
bracket and the door handle to the new panel.
Fit the panel to the door and reassemble in reverse order.
18. To Replace the Tall Oven Door Magnetic Latch
Remove the control panel - see section 1. Remove the plinth
(three screws) and the central vertical cover (five screws).
Prize the retaining clip off the magnet unit.
Fit the new unit and retaining clip, and reassemble in reverse
order. Verify that the door operation is correct.
19. To Replace a Grill Element
Remove the grill pan from the grill chamber. From inside the
grill compartment, remove the enamelled front shield from
the grill roof, by undoing the two screws and washers.
Remove the two screws and washers securing the grill
element front support. Remove the screws from the grill
element.
Lift the element out carefully, disconnecting the leads
from the element terminals (noting their position). If it is
not possible to disconnect the leads in this way, pull the
cooker forward to gain access to the rear, remove the screws
securing the electric cover to the back sheet, remove the
cover and disconnect the terminals from the rear.