17 U109655
Australia
the control panel and knobs (although we do supply a
specialist Fascia Cleaner). After cleaning, polish with a dry
cloth.
The Main Oven
The oven door front panel can be taken off so that the
glass panels can be cleaned. Firstly, move the cooker
forward to gain access to the sides (see ‘Repositioning the
Cooker following Connection’ under
Installation
).
Door Panel
Open the oven door slightly and remove the front panel
fixing screws from the door sides (two each side):
Carefully lift off the outer door panel. The inside face of
the glass panels can now be cleaned - take care not to
disturb or wet the door insulation.
The door is triple glazed but the inner two panels are
fixed and should not be separated. After cleaning,
carefully refit the outer door panel and replace the side
fixing screws.
'Cook & Clean' Panels
The main oven has side 'Cook & Clean' panels which have
been coated with a special enamel that partly cleans itself.
This does not stop all marks on the lining, but helps to
reduce the amount of manual cleaning needed.
These panels work better above 200°C. If you do most
of your cooking below this temperature, occasionally
remove the panels and wipe with a lint free cloth and
hot soapy water. The panels should then be dried and
replaced and the oven heated at 200°C for about one
hour. This will ensure that the panels are working
effectively.
Removing the Panels to clean the Enamel Interior
If you wish to clean the enamel interior of the oven, you
will need to remove the shelves, followed by the 'Cook
& Clean' panels. Each side of the oven is fixed with four
fixing screws. You don’t have to remove the screws to
remove the oven panels - simply lift each side panel
upwards and they will slide off the screws. Then pull them
forwards:
Once the panels have been removed, the oven enamel
interior can be cleaned.
Don’t use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.
The Tall Oven
To clean the oven sides, slide out the shelves, unhook the
supports from the oven sides, and lift out:
Troubleshooting
A crack has appeared in the hob surface
Disconnect the cooker immediately from the power
supply and arrange for its repair. Don’t use the cooker
until after the repair.
My hob is scratched
Always use the cleaning methods recommended in this
guide, and ensure that the pan bottoms are smooth and
clean.
Marks from aluminium and copper pans as well as
mineral deposits from water or food can be removed
with a cleaning cream. However, tiny scratches are not
removable but will become less visible in time as a result
of cleaning.
The oven fan is noisy
The note of the oven fan may change as the oven heats
up - this is perfectly normal.
Grill not cooking properly
Are you using the pan and trivet supplied with the
cooker? Is the pan being used on the runners, not the
Summary of Contents for Elan 90 Ceramic
Page 27: ...27 109655 Australia Circuit Diagram...
Page 30: ...U109655 30 Australia...
Page 31: ...31 109655 Australia...
Page 32: ......
