21 U109655
INSTALLATION
Check that the appliance is electrically safe when you have finished.
Australia
Make 10 complete (360º) turns clockwise. (This means
turning and removing the levelling tool 20 times.)
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the front
bottom corners of the cooker.
Unfold the rear edge of the pack base tray. Open the grill
door and right hand oven door so that you can get a good
grip on the bottom of the fascia panel as you move the
oven:
Grip under the fascia panel and lift the front of the cooker
slightly:
Carefully push the cooker backwards off the pack base.
Remove the pack base tray. Position the cooker close to its
final position, leaving just enough space to get behind it.
Repositioning the Cooker following Connection
If you need to move the cooker once it has been
connected, then you need to unplug it and, having
gripped under the fascia panel and lifted the front of
the cooker slightly (as shown above), you need to check
behind the cooker to ensure that the electricity cable has
sufficient slack to allow the cooker to move.
Levelling
It is recommended that you use a spirit level on a shelf in
one of the ovens to check for level. Ensure that the cooker
is in its intended position, taking care not to twist it within
the gap between the kitchen units, as damage may occur
to the cooker or units. The front feet and rear rollers can
be adjusted to level the cooker. To adjust the height of
the rear of the cooker, use the levelling tool supplied to
turn the adjusting nuts at the front bottom corners of the
cooker. To set the front feet, simply turn the bases to raise
or lower them.
Leave the levelling tool with the customer, so that they
can use it if they wish to move the cooker again.
Fitting the Handles and Front Handrail
Remove the 4mm Allen screws from the doors with the
hexagon key tool. Use the screws to fit the door handles.
The handles should be above the fixings.
Fit the plastic blanking plugs to the fixing holes. Remove
the 4mm Allen screws from the top corners of the fascia
and fix the front handrail in position.
Summary of Contents for Elan 90 Ceramic
Page 27: ...27 109655 Australia Circuit Diagram...
Page 30: ...U109655 30 Australia...
Page 31: ...31 109655 Australia...
Page 32: ......
