U109655 20
INSTALLATION
Check that the appliance is electrically safe when you have finished.
Australia
Positioning the Cooker
The diagrams below show the minimum recommended
distance from the cooker to nearby surfaces.
The hob should be level with, or above, any adjacent work
surface. Above hob level, a gap of 75mm should be left
between each side of the cooker and any adjacent vertical
surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25mm.
A minimum space of 650mm is required between the top
of the hob and a horizontal combustible surface.
The following diagram shows suggested clearances above
the cooker:
* Any cooker hood should be installed in accordance
with the hood manufacturer’s instructions.
Surfaces of furniture and walls at the sides and rear of
the appliance should be heat, splash and steam resistant.
Certain types of vinyl or laminate kitchen furniture are
particularly prone to heat damage and discolouration.
We cannot accept responsibility for damage caused
by normal use of the cooker to any material that de-
laminates or discolours at temperatures less than 65°C
above room temperature.
For safety reasons, curtains must not be fitted
immediately behind the cooker.
We recommend a gap of 1110mm between units to
allow for moving the cooker. Do not box the cooker in; it
must still be possible to move the cooker in and out for
cleaning and servicing. The cooker should not be placed
on a base.
Plan view - a clearance of 130mm each side is required to allow for oven
door opening.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly
in front of the location where is to be installed (unless it
will not fit through a door in its outer packaging). Cut the
banding straps and lift the cardboard box off the cooker,
leaving the cooker standing on the base packaging. See
the loose unpacking sheet.
Moving the Cooker
On no account try and move the cooker while it is
plugged into the electricity supply.
The cooker is very heavy, and great care needs to be
taken. We recommend that two people manoeuvre it.
Ensure that the floor covering is firmly fixed, or removed,
to prevent it being disturbed when moving the cooker
around.
To help you, there are two levelling rollers at the back,
and two screw-down levelling feet at the front. You will
need the levelling tool.
Remove the polystyrene base pack. From the front, tilt
the cooker forward and remove the front half of the
polystyrene base:
Repeat from the back and remove the rear half of the
polystyrene base.
Lowering the Two Rear Rollers
Firstly, fit the levelling tool on the hexagonal adjusting
nut, as shown below:
Summary of Contents for Elan 90 Ceramic
Page 27: ...27 109655 Australia Circuit Diagram...
Page 30: ...U109655 30 Australia...
Page 31: ...31 109655 Australia...
Page 32: ......