15
Never remove the lever cover.
Do not loosen the lever cover installation bolt.
Lever (B)
New Cable
Old Cable
Right hand lever, rear gear
Gear Inner Wire Replacement & Connection
STI Adjustment — Noise prevention mechanism
If chain noise occurs, due to overshifting,
when a shift is made from the smallest
chainwheel to the intermediate
chainwheel, the overshifting can be
adjusted by gently pressing lever (b) to
move the front derailleur slightly toward
the small chain wheel, thus activating
the noise prevention mechanism.
Installation to the Handlebar
Move lever (a) (and lever (A) when
installing the right hand lever) so that
the installation bolt can be seen and
then use an Allen key to install a torque
of
6 - 8 Nm (4.5 - 6lb-ft).
Allen Key
Lever b
Lever (a)
Press Lever
(a) to
reveal the
installation
bolt
Left hand lever operating front
gear changer viewed from below
Installation of the brake cables
Use the 1.6 mm diameter inner cable and the 5 mm diameter outer casing.
1
.
Insert the cable barrel nipple through the brake lever body.
2
.
Mount the nipple into the retaining hole in the lever.
3
.
Ensure the brake adjusting bolt and nut are seated correctly in the lever.
4
.
Adjust the lever adjustment screw to obtain the desired grip width
5
.
Before riding, test the brakes several times to ensure everything is seated correctly and
that the brakes are functioning properly. Readjust as necessary.
IF IN DOUBT ABOUT BRAKE FUNCTIONING
CONSULT YOUR LOCAL DEALER.
Wire holding plate
Holding nut
Groove
Outer adjustment bolt
Dust Cover
Lever adjustment
screw
Left hand lever viewed from below
Cable barrel nipple
Adjust grip width
using lever adjustment screw
For the rear, press lever (B) six times or more, and then, for the front, press lever (b) three or
four times.
Push out the old cable through the lever cover and replace with the new cable.
Left hand lever, front gear
Lever (b)
New Cable
Old Cable
