FALCOM A2
A2MAN.DOC
08 MARCH 1999
This confidential document is the property of Funkanlagen Leipoldt OHG and may not be copied or circulated without permission.
Page 12
1.4
Call control commands
1.4.1
ATD;
Command is used to establish a voice call, if the semicolon at the end of the
number is applied.
Command
Possible responses
ATD<number>;
OK If call is established
BUSY If called party is in another call
NO ANSWER If called party does not accept a call
NO CARRIER If there are problems to establish a call
Defined values:
<number>:
telephone number to dial.
Remarks:
In case of international number, the local
international prefix (usually 00) could be replaced
by the '+' character.
For phonebook dialling please see phonebook
commands section.
Source:
GSM 07.07/V.25ter/6.3.1
Implementation:
yes
1.4.2
ATD
Command is used to establish a data call.
Command
Possible responses
ATD<number>
CONNECT<speed> If call is established
BUSY If called party is in another call
NO ANSWER If called party does not accept a call
NO CARRIER If there are problems to establish a call
Defined values:
<speed>:
link baud rate between modem and network
Remarks:
Bearer type should be selected before (see at+cbst).
For phonebook dialling please see phonebook
commands section.
Source:
GSM 07.07/V.25ter/6.3.1
Implementation:
yes
