____________________________________________________________________________
- 17 -
2.6 Installing
2.6.1 Preparation For Use
(1) Ensure the Power Supply is connected to the AC line input that meets the specification.
(2) The instrument must be installed in an area with good air circulation to avoid the internal temperature getting
too high.
(3) For indoor use only, ambient temperature 0°C to 40°C.
2.6.2 Requirements of Input Power
Please pay attention to the following items for FTP series power supply input connection:
①
Single phase AC input: 190VAC~265VAC, 47~63Hz;
②
Ensure reliable grounding;
③
The AC power cord temperature resistance is greater than 85
℃
;
④
Please refer to "Table 6-1 Recommended Wire Diameters for Cables" for the selection of input wire diameters
to avoid potential safety hazards due to thinner wire diameters.
----------------------------------------------------------------------------------------------------------------------------
1. To protect the operator, the wire connected to the GND terminal must be connected to
the earth. Under no circumstances shall this DC Power Supply be operated without an
adequate ground connection.
2. Installation of the power cord must be done by a professional and compliant with local
electrical codes.
----------------------------------------------------------------------------------------------------------------------------
2.6.3 Power ON Self Check
When powered on, the power supply will conduct self check, the check process and results will be displayed on
the screen, such as below:
Figure 2-5 FTP Power ON Self Check
The power supply will enter MAIN PAGE if all checking results are OK.
If there is FAULT during power supply power on self check, please contact authorized Faithtech agent or Faithtech
after-sale service.
Summary of Contents for FTP Series
Page 2: ......
