Section:
Chapter: 5
Page
PROGRAM EXECUTION
6
5.4 DISPLAY OF THE ARITHMETIC PARAMETERS
Once one of the execution modes is selected, Automatic or Single-Block, this mode may
be access by pressing [P]. The information appearing on the displays looks like this:
The top display shows the number of the parameter
currently selected.
The bottom display shows the arithmetic value of that
parameter.
The CNC has 100 arithmetic parameters (00/99). Their
values may have a sign, decimals and may be represented in exponential form.
0.98700 -1
Is the same as 0.98700 10
-1
1298700 7
Is the same as 1298700 10
7
If the exponent of the arithmetic parameter to be displayed is greater than 9, the first digit
on the right will show the "-" sign.
Use the
keys to view the previous and following parameters.
To quit this display mode:
Press [CL]. The CNC returns to the previous display mode (either the standard one or
a specific one).
Press [A+] or [A-]. The CNC will show one of the specific display modes.
5.5 CHANGE OF OPERATING MODE
With this CNC it is possible to change from Automatic mode to Single-Block mode or vice-
versa while running a program. To do this, press the key corresponding to the desired
operating mode:
or
To quit the execution mode and switch to another operating mode, the program must not
be running. Therefore, the program must be interrupted or ended.
ARITHMETIC PARAMETERS
CHANGE OPERATING MODE
