![FAG Detector III Manual Download Page 45](http://html1.mh-extra.com/html/fag/detector-iii/detector-iii_manual_3173195045.webp)
45
Trendline 3
1. Select the measuring point in the Trendline configuration.
2. Click on the
Configuration
tab.
3. In the RFID Status box select
Edit RFID
.
4. Send
the configuration to the Detector.
5. During the round, select the appropriate measuring point in the Detector (see
Selection of measuring point
).
6. Select
Start measurement
. The Detector prompts you to delete the tag.
a) Delete the tag and select
Tag deleted
. You can now assign the new RFID
tag.
b) If you do not delete the tag, select
Tag stays
.
7. Continue measuring.
8. Load the data from the Detector in Trendline. The new RFID tag is assigned in
the measuring point in the system configuration.
Exchanging a defective RFID tag
If communication with the RFID tag at a measuring point does not work, the user
can mark it as "defective" in the Detector and then continue measuring. After the
next data synchronization with the Trendline software, the RFID status "RFID
defective" is displayed at the measuring point and recursively up to the top level in
the configuration tree. You can then assign a different RFID tag to the measuring
point.
1. The Detector cannot read the RFID tag at the measuring point. Select
RFID tag
defective
in the Detector.
2. The program displays "Is the tag defective?". Select
Yes
.
3. Delete the RFID tag from the measuring point.
4. Load the data from the Detector in Trendline. The RFID status of the measuring
points is now set to "RFID defective".
5. You can now assign a different RFID tag to the measuring point.
Additional information
·
You can abort Detector RFID tag assignment handling functions by pressing
Esc
. This preserves the previous state of the assignment.
·
If the Detector recognizes an RFID tag that is not in the configuration, it displays
the error message: "At least one configuration does not exist".
3.4.3 Create a measuring point
The settings for the measuring point can now be made. Three tabs are assigned to
each measuring point in the right-hand window: Information
, Configuration
and Measured values
.
67
183
46
46
88