33
English
English
Programming the coffee measures
“ Before programming the coffee dispensing push
buttons fill the filter holder with the correct serving
of ground coffee. Don’t use coffee grouts for
programming servings.”
Fit and tighten the filter holder (
10
) on the coffee dispenser
unit, positioning the cup (or cups) under the nozzle (or nozzles)
of the filter holder (
10
).
Press (and keep momentarily pressed) the coffee dispensing
push button (
16, 17, 19
or
20
) corresponding to the required
serving to be programmed.
When the amount of coffee in the cup reaches the required
level, release the coffee dispensing push button.
Repeat the above operations for the other coffee push
buttons.
Note: if you make a programming mistake, use a new dose
of ground coffee and repeat the operation.
!!!!!
10
10
17
19 20
16
!!!!!
Programming the hot water measures
After positioning the correct container under the hot water
nozzle (
8
), raise the hot water dispensing lever (
9
) to release
water.
Once the amount of water reaches the desired level, release
the lever (
9
): this sets the programmed dose.
1 DISPENSER UNIT MACHINES
To perform the programming of the water dose follow the
procedure here below:
1)Place a container by the hot water distribution nozzle (
8
).
2) Keep the distributor key (
9
).
3) When the quantity of water in the container has reached
the desired level, press again the key (
9
).
9
8
8
9
1 Dispenser unit machines
