fadini Elpro 43, Manual, Page: 14 / 32

ELECTRONIC CONTROLLER FOR DARDO 430 GATE OPERATOR
ON DOUBLE SWINGING GATES
Elpro 43
GB
14
PROGRAMMING THE UNIT TO OPERATE ON NO GATE LEAF DELAY MODE
Adjust the force and dwell trimmers according to the actual site requirements and type of gate to operate, in full respect of the “the
Force Limitation directive in compliance with EN 12453 and EN 12445 norms”.
IMPORTANT: any time force trimmers are readjusted, it is required that programming be made anew.
-
+
NOTE VERY WELL: all of the green LEDs must be ON, otherwise check the connections with any accessory, mainly the NC contacts
of the safety devices installed (contacts of the inner and outer photocells, stop contact, safety edges, ...).
EXCLUDING GATE LEAF DELAY ON PROGRAMMING
(when it is required that both gate leafs be opened simultaneously and for single gate applications where one motor only is involved).
Once all the electrical connections to the control unit have been properly made (following the instructions included in the box) with all of the safety
and command accessories as required, programming can be carried out.
!
1 pulse
LP
LP
LP
LP
1)
2)
3)
4)
5 seconds
LP LP
LP
LP
LP
Press and hold the programming button for 5 seconds (until the LP led
starts flashing): programming mode is thus accessed.
Pulse just once: the LP led light is steady
on, wait.
After
10 seconds the LP led light goes off
and the gate leaves open simultaneously
untill the gate stop is reached in open
limit position.
With the gate in the open limit position the
LP led goes on with steady light:
wait about
10 seconds (do NOT press the button) . The
LP led goes off and the gate leaves move in
close direction until gate stop is reached.
LP led OFF and flasher OFF indicate that
programming is finished.