GENERAL DESCRIPTION OF THE PRODUCT
Dardo 430
is a electromechanical operator for external mount on swinging gates in residential and block of flats applications. It
comes in a kit format to operate two gate leafs. Command and safety accessories for a proper performance are included. It is a non
reversible, 230 Vac power supplied motor-operator, complete with an incorporated encoder. Stop plates are fitted to the pressure
cast aluminium body. The linear movements are by a brass shaft nut (threaded bush) and a screw shaft (rolled thread), all
supported by a radial bearing and a lubricated bushing.
In case of an electric power failure, Dardo 430 can be “released” by a custom-made, coded key and the gates moved by hand.
Terminals are factory fitted to each operator and provide connections for the power supply and the encoder to the electronic
controller
Elpro 43 ,
to be installed stand alone, in a sheltered place.
NOTE: The Dardo operators are not handed units and therefore they come all alike both for the right and the left gates: following
their respective connections to the Elpro 43 controller, they are identified as Dardo M1 (first gate to open and pedestriam mode)
and Dardo M2 (gate delayed on opening) (Pic.3).
Dardo does not come fitted with electronic limit switches as they are not necessary, limit stop positions are learned by the system
in phase of programming as determined by the incorporated stop plates.
Pic. 1 displays all of the components that are delivered for the installation of each Dardo operator.
PRODUCT APPLICATIONS
EQUIPMENT REQUIRED FOR THE INSTALLATION
Pic. 1
Pic. 2
FA
D
IN
I
FADINI
Sliding cover with lock as a
protection of the manual
release device
(Pic.12, page 22)
Front bracket for
fixing to gate
Max. width per leaf
L (m)
Max. weight per leaf
P (kg)
The table below shows the maximum dimensions of a gate leaf in relation to its maximum weight.
cod. 430L - DARDO 430 - 230 Vac
Rear bracket
for fixing
to gate post
Stop plates in
open gate position
Coded key for
manual release
Stop plates in
closed gate position
Inner
Innner
Outer
Outer
M8
M8
NOTE: the gate structure should not be fully panelled without openings, avoid that in-filling is more than 50% of the gate surface.
E13
Rear cap to protect the
electrical connections to the
inner terminal blocks
Cable inlet for
power supply and encoder
electromechanical operator for swinging gates
DARDO 430
DARDO 430
English
17
2,0 2,5 2,8
350 300 250
Summary of Contents for DARDO 430
Page 13: ...apricancello elettromeccanico per cancelli a battente DARDO 430 DARDO 430 Italiano 13 ...
Page 27: ...electromechanical operator for swinging gates DARDO 430 DARDO 430 English 27 ...
Page 41: ...automatisme électromécanique pour portails à battant DARDO 430 DARDO 430 Français 41 ...
Page 55: ...elektromechanischer Drehtorantrieb DARDO 430 DARDO 430 Deutsch 55 ...