FactoryCat 2023, Manual

Page: 17 / 72

OPEN RECOVERY LID
1. RELEASE BOTH LATCHES ON RECOVERY TANK LID.
(SEE FIGURE 20.)
2. ROTATE LID FULLY OPEN.
CLEAN "DRAIN SAVER"
WITH RECOVERY LID OPEN & TANK FULLY DRAINED
1. REMOVE 2" SQUEEGEE INTAKE HOSE FROM
"DRAIN SAVER" STRAINER.
(SEE FIGURE 23.)
2. REMOVE STAINLESS SCREEN, DISPOSE OF DEBRIS.
3. RINSE SCREEN WITH FRESH WATER FROM THE OUTSIDE
TO THE INSIDE HOLDING SCREEN UPSIDE DOWN.
THIS WILL ALLOW FOR BETTER CLEANING.
4. REPLACE THE SCREEN INTO THE BRACKET.
5. REPLACE 2" SQUEEGEE INTAKE HOSE.
FIGURE 20.
FIGURE 23.
FLUSH RECOVERY TANK
1. RINSE THE RECOVERY TANK AFTER EVERY USE. THIS
WILL PREVENT HEAVY BUILDUP ON THE BOTTOM OF
THE TANK, FOUL ODERS, AND CLOGGING OF THE
DRAIN HOSE.
(SEE FIGURE 21.)
PAGE 15
2. ONCE THE TANK IS EMPTY, PUT DRAIN HOSE CAP ON AND
TIGHTEN BY TURNING CLOCK WISE. REINSTALL ON J-HOOK.
(SEE FIGURE 22.)
FIGURE 21.
CLEAN VAC SCREEN
WITH RECOVERY LID OPEN & TANK FULLY DRAINED
1. REMOVE VAC SCREEN RETAINING CLIP "A".
(SEE FIGURE 24.)
2. PULL VAC SCREEN AND FLOAT BALL ASSEMBLY
OFF THE VAC BOX.
3. RINSE WITH HOT WATER.
4. DRY THOROUGHLY.
5. REPLACE VAC SCREEN ONTO BOX.
6. REPLACE AND TIGHTEN RETAINING CLIP.
FIGURE 24.
A
FIGURE 22.