PAGE 8
CONTROLS AND FUNCTIONS
SEE FIGURES (1-4) ON PAGE 7
SEE FIGURE 1
1. MAIN POWER SWITCH:
TURNS THE MACHINE ON AND OFF.
2. VACUUM SWITCH:
TURNS VACUUM MOTOR ON.
3. SOLUTION SWITCH:
OPENS AND CLOSES SOLUTION VALVE.
4. SCRUB DECK SWITCH:
RAISES AND LOWERS SCRUB DECK (PROVIDES AJDU/- FOR PRESSURE).
5. BATTERY GAUGE:
INDICATES AMOUNT OF BATTERY CHARGE .
6. POWER LIGHT (GREEN):
INDICATES POWER "ON"
.
7. DOWN PRESSURE GAUGE:
INDICATES AMOUNT OF PAD/BRUSH PRESSURE.
SEE FIGURE 2
8. EMERGENCY STOP (OPTIONAL):
SHUTS OFF POWER TO THE MACHINE .
9. KEY SWITCH (OPTIONAL):
TURNS POWER ON TO THE MACHINE.
10. CIRCUIT BREAKER:
2 AMP RESETABLE CIRCUIT BREAKER (ACTUATOR).
11. CIRCUIT BREAKER:
25 AMP RESETABLE CIRCUIT BREAKER (VACUUM MOTOR).
12. CIRCUIT BREAKER:
30 AMP RESETABLE CIRCUIT BREAKER (SCRUB MOTOR).
13. SPRAY JET (OPTIONAL):
TURNS ON THE SPRAY JET PUMP (BLUE).
14. HOUR METER:
INDICATES HOW MANY HOURS THE MACHINE HAS BEEN RUN.
15. SERIAL NUMBER PLATE:
MACHINE IDENTIFICATION
.
SEE FIGURE 3
16. RECOVERY LID:
USED FOR FLUSHING OUT RECOVERY TANK AREA WITH FRESH WATER.
17. DRIVE BUTTON:
DEPRESS TO DRIVE FORWARD, RELEASE TO STOP. (STARTS & STOPS THE SCRUB MOTOR)
18. "DRAIN SAVER" STRAINER:
HELPS PREVENT CLOGGING OF DRAIN PORTS.
19. VAC SCREEN:
PROTECTS VAC MOTOR FROM DEBRIS.
20. CASTER:
TWIN CASTERS FOR STABILITY.
21. MAIN TIRE:
NON-MARKING TIRES.
22. SOLUTION VALVE:
CONTROLS SOLUTION FLOW RATE, WHEN SOLUTION SWITCH IS ON.
23.
SPLASH CURTAIN:
HELPS CONTAIN WATER INSIDE SCRUB AREA.
24. WALL ROLLERS:
HELPS PROTECT MACHINE WHEN SCRUBBING NEAR WALLS.
25. "PAD ASSIST" DRIVE ADJUSTMENT KNOB:
ADJUSTS AMOUNT OF OFFSET BEING APPLIED TO BRUSH.
26. TANK-IN-TANK:
SOLUTION/RECOVERY TANK(18 GALLON CAPACITY EACH).
27. SOLUTION FILL LID:
FILL PORT FOR FILLING SOLUTION TANK.
SEE FIGURE 4
28. CLEAR COVER:
FOR VIEWING INSIDE RECOVERY TANK AREA.
29. CONTROL PANEL:
MACHINE CONTROLS.
30. RECOVERY DRAIN HOSE:
ALLOWS FOR CONTROLLED DRAINING OF RECOVERY TANK.
31. RECHARGE PLUG:
RED 50 USED TO RECEIVE CHARGER INPUT.
NOTE:
ONLY USE CHARGER PROVIDED.
32. BATTERIES:
YOUR MACHINE IS EQUIPPED WITH TWO (12 VOLT DEEP CYCLE 140 AMP HOUR BATTERIES).
33. SQUEEGEE BLADE:
RECOVERS DIRTY WATER FROM FLOOR TO BE RECOVERED BY THE VACUUM HOSE.
34. VACUUM HOSE:
VACUUMIZES SQUEEGEE.
NOTE:
KEEP FREE AND CLEAR OF BLOCKAGE.
35. SQUEEGEE PITCH ADJUSTMENT:
ADJUSTS PITCH OF SQUEEGEE. DEFLECTION SHOULD BE EVEN ACROSS ENTIRE BLADE.
36. SQUEEGEE LIFT POST:
LIFT TO RAISE SQUEEGEE AND PUSH DOWN TO LOWER SQUEEGEE
.
37. SOLUTION FILTER:
HELPS CLEAN WATER IN PREPERATION FOR SCRUBBING.
38. SOLUTION LEVEL INDICATOR & DRAIN TUBE:
SHOWS PRECISE LEVEL OF CLEANING SOLUTION IN TANK & DRAIN PORT.
Summary of Contents for 2023
