FactoryCat 2023, Manual

Page: 15 / 72

ONE PASS SCRUBBING
(SEE FIGURE'S 13 & 14.)
1. TURN ON MACHINE POWER SWITCH "A" ,
MAKE SURE THE "PAD ASSIST" ADJUSTMENT KNOB
IS A LOW SETTING.
2. LOWER SQUEEGEE BY ROTATING THE LIFT LEVER
"B"
COUNTER-CLOCKWISE.
3. LOWER SCRUB HEAD TO THE FLOOR, USE THE
TOP HALF (+) OF THE BRUSH SWITCH
"C" .
4. TURN ON THE SOLUTION SWITCH "D" .
5. TURN ON THE VACUUM MOTOR SWITCH
"E"
.
6. BEGIN SCRUBBING BY DEPRESSING THE GREEN
CONTROL BUTTON
"F" . ADJUST THE "PAD ASSIST"
ADJUSTMENT KNOB TO THE DESIRED SETTING.
7. ONCE THE MACHINE BEGINS TO MOVE,
CHECK THE DOWN PRESSURE GAUGE
"G"
.
START SCRUBBING AT THE MIDDLE.
DO NOT SCRUB IN THE RED, OR THE CIRCUIT
BREAKER WILL BLOW.
8. TO STOP THE MACHINE, LET GO OF THE GREEN
CONTROL BUTTON
"F"
.
FIGURE 13.
B
FIGURE 14.
A
C
D
F
G
E
PAGE 13
SCRUB ONLY
(SEE FIGURE 14.)
1. TURN ON MACHINE POWER SWITCH
"A"
,
MAKE SURE THE "PAD ASSIST" ADJUSTMENT KNOB
IS A LOW SETTING.
2. LOWER SCRUB HEAD TO THE FLOOR, USE THE
TOP HALF (+) OF THE BRUSH SWITCH
"C"
.
4. TURN ON THE SOLUTION SWITCH
"D"
.
5. BEGIN SCRUBBING BY DEPRESSING THE GREEN
CONTROL BUTTON
"F"
. ADJUST THE "PAD ASSIST"
ADJUSTMENT KNOB TO THE DESIRED SETTING.
6. ONCE THE MACHINE BEGINS TO MOVE,
CHECK THE DOWN PRESSURE GAUGE
"G" .
START SCRUBBING AT THE MIDDLE.
DO NOT SCRUB IN THE RED, OR THE CIRCUIT
BREAKER WILL BLOW.
7. TO STOP THE MACHINE, LET GO OF THE GREEN
CONTROL BUTTON
"F" .
VACUUM ONLY
(SEE FIGURE'S 13 & 14.)
1. TURN ON MACHINE POWER SWITCH "A" .
2. LOWER SQUEEGEE BY ROTATING THE LIFT LEVER "B"
COUNTER-CLOCKWISE.
3. TURN ON VACUUM SWITCH "E" .
4. PUSH MACHINE FORWARD OVER SOLUTION.