Fac F300 VO L, Use And Maintenance Manual

Page: 19 / 68

19
Fig. 8
31
7
32
x
30
7
Fig. 7
31
32
30
Fig. 6 5
4
IT
EN
• Remove the taper pin (30) from the
flywheel shaft (31).
Use a hammer to hit the
taper pin (30) on its smaller
diameter.
• Fit the shim (32) to the flywheel shaft
(31).
• Insert the flywheel (7) so that the
operating handle (6) fixing hole (x) is
positioned above and to the left of the
axis of the taper pin hole (fig. 8).
Check that flywheel and shaft
holes are correctly aligned.
• Insert the taper pin (30) in the hole of the
sleeve
> > > > >
4
.1 - Fitting the flywheel and oper-
ating handle
For transport requirements, sometimes the
manoeuvre handle (6) and the flywheel (7)
can be removed.
In order to fit components, please proceed as follows:
• Move the carriage (5) as near to the
operator as possible.