13.
Locate FT95074 Front Long travel Axle, FT95060 Clamp
Kit with Snap Rings, and the factory outer CV and Boot.
Open the clamp and snap ring kit and the factory snap rings
which were just removed. Match the old snap rings to the
new ones in the kit (provided FT95060 kit has snap rings for
all EIGHT CV’s). Place the CV boot onto the axle and
follow with the small snap ring (one wire style) onto the
large splined end of new long travel axle. Place the outer CV
into a vise and LIGHTLY tighten enough just to hold the
CV. With the boot and C-Clip installed, insert the axle into
the CV to where the clip makes contact with the CV. Use a
soft brass or rubber mallet and carefully strike the axle
downward to engage the inner snap ring into the CV. Slide
boot down over the CV. SEE PHOTOS & DIAGRAM ON
NEXT PAGE & LAST PAGE OF INSTRUCTIONS
