55.
Locate FTR60141 Rear Shock, provided shock mis-
alignments, supplied (4) 7/16” washers, and the factory
shock hardware. Insert the shorter mis-alignments into the
heim on the bottom of the shock. Mount the bottom of the
shock to the lower control arm mounts with the shock
reservoir facing to the rear of the Rhino with the factory
hardware with 2 of the supplied 7/16” washers. Insert the
large mis-alignments into the top of the shock and mount
into the stock upper mount with the factory hardware. (use
supplied thread-locking compound) Torque the upper and
lower shock bolts to 32lbs.
SEE PHOTOS ON NEXT
PAGE & SEE DIAGRAM ON LAST PAGE FOR PROPER
MIS-ALIGNMENT LOCATIONS.
Rear of Rhino
Photo of passenger rear
56.
Locate FT83178 Rear Resi Mount Bracket and FT86013
Hardware kit that is provided with the rear shocks.
NOTE:
some 2005 & 2006 model rhinos have a factory locating
hole.
If your Rhino has this locating hole on the backside of
the frame section just above where the rear upper control
arm mounts to the frame, use a drill with a 5/16” drill bit and
drill out to 5/16”. Locate the supplied 5/16” hardware and
