29.
Locate and install the factory hub assembly onto the knuckle
and axle shaft. Install the factory axle shaft nut and torque to
190 lbs. Use a center punch and re-crimp the hub nut in the
key way of the axle. SEE PHOTO BELOW
30.
Locate the 10mm brake caliper bolts and re-attach the rotor.
Torque to 35 lbs. (use supplied thread-locking compound)
Locate the two of the supplied adel clamps and ¼”
hardware. Position the adel clamps over the brake hose and
attach to the tabs on the upper control arms. Torque to 10
lbs. SEE PHOTOS BELOW
1 – 3/8” USS
Flat Washer
1 - 3/8” SAE
Flat Washer
