IMPULSE COMMAND
MOTOR 1
ò
OPEN
ñ
CLOSE
CLEAR STOP
ENT CONT.
Motor M1 operation test:
ò
= Start motor M1 for opening
= Start motor M1 for closure
CLEAR = Stop movement
ENTER = Stop movement and go to subsequent menu
ò
ENTER
PG
PG
CLEAR
ESC
1
F1
2
F2
ENTER
ENTER
IMPULSE COMMAND
MOTOR 2
ò
OPEN
ñ
CLOSE
CLEAR STOP
ENT CONT.
13
2) LAMP = State of warning lamp
The possible states are:
- ON
= Warning light on
- OFF
= Warning light off
3) OUT F.TX = State of photocell projector power supply
The possible states are:
- ON
= Supply to projectors on
- OFF
= Supply to projectors off
If the Failsafe is not enabled, the normal state is ON. Only when the photocell
check is performed (Failsafe enabled) does the state momentarily become OFF.
4) RX = Result of FAILSAFE check
The possible states are:
- OK = The Failsafe has run correctly
- KO = The Failsafe has found a fault
With the FAACTOTUM connected to the card, it is possible to check the state of
the automation according to the operation of the various activation devices
under this menu.
Press ENTER to continue.
➲
This menu appears only if “NUMBER OF OPERATORS = 2” has been set.
Motor M2 operation test:
ò
= Start motor M2 for opening
= Start motor M2 for closure
CLEAR = Stop the movement
ENTER = Stop movement and go to next menu
ò
ENTER
PG
PG
CLEAR
ESC
CYCLES COUNTER
TOTAL
XXXXXXXX
CYCLES COUNTER
PARTIAL
XXXXXXXX
CLEAR RESET
ENTER
ENTER
IMPULSE COMMAND
1 OPEN-A
2 OPEN-B
3 STOP
4 CLOSE
ESC TO EXIT
From the time of its installation, the 460P counts the number of cycles performed
by the automation to give an idea of its degree of usage.
A cycle is counted upon each opening movement.
The total number of cycles (which cannot be reset) is shown in this menu.
Press ENTER to continue.
Display of number of cycles performed since last reset.
Press the CLEAR key to reset the counter.
Press ENTER to continue.
➲
The number of partial cycles is contained inside the configuration program
and is overwritten every time a program (saved in the FAACTOTUM internal
memory) is transferred to the card.
The control pulses are sent using the following number keys:
1=OPEN-A
2=OPEN-B
3=STOP
4=CLOSE
➲
Whereas the control pulses sent by external activation devices reach the
microprocessor via special electronic components called optoisolators, those
sent via the FAACTOTUM reach the microprocessor directly.
This means that it is possible not only to test the automation without the need
to operate on the external activation devices, but also to test the efficiency of
the optoisolators.
Press ENTER to continue.
TEST MOTOR?
1->YES
2 NO
ENTER
SELECT MODE
(cont.)
(cont.)
ENTER
ENTER
ENTER
ESC
CLEAR
1
F1
2
F2
3
F3
4
F4
Select option:
1 = Perform motor operation test
2 = Do not perform motor operation test
1
F1
2
F2
or
ENTER
+
Make the selection by moving the arrow-shaped cursor alongside the desired
option using the
ï
and
ð
keys and pressing ENTER, or key in the corresponding
number directly.
