FAAC E550, Manual

Page: 9 / 12

8
ENGLISH
bo
MAXIMUM TORQUE AT THRUST:
Y
= Active
no
= Excluded
Y
FS
FAIL SAFE (safety devices operational check):
Y
= Active
no
= Excluded
no
PF
PRE-FLASHING of flashing light:
Can be adjusted from
0
to
10
sec in one-second steps.
00
FC
LIMIT SWITCH TRIPPING MODE:
no
= FCA/FCC: Stops immediately.
Y
= FCA/FCC: Stops after a 3 sec. slow-down.
Y
Ph
SAFETY DEVICES TRIPPING MODE:
Sets motor operation when safety devices engaged:
St
= FSW OP locks opening movement, and on release, resumes opening.
Ad
= When up-and-over idle (closed, open or locked) and FSW CLs engaged, an OPEN pulse activates the
flashing light, but movement begins only when FSW CL
(1)
(ADMAP function) disengages.
While the door is moving, FWS OP reverses and FSW CL locks and reverses at disengagement
(1)
.
CL
= FSW OP reverses the opening movement, FSW CL reverses closing movement.
(1)
With pre-flashing selected, movement begins after the set pre-flashing time.
CL
In
To exit programming and return to display of inputs status.
(see chapter 6)
8 AUTOMATED SYSTEM TEST
When you have finished programming, check if the system is operating correctly.
Check if force is adequately adjusted and if the safety devices operate correctly.
Also run the impact test and see if it conforms to current regulations.
Otherwise, change the force, speed and sensitivity parameters in order to be again within the set values.
9 OPERATION OF ENCODER AND ELECTRONIC CLUTCH (ANTI-CRUSHING)
Thanks to encoder control and an electronic system for adjusting motor torque, the E550 board, if correctly used,
guarantees installation conforming to current safety regulations.
The encoder is active during both door opening and closing stages, until one of the two limit switches is tripped.
The encoder intervenes during opening, stopping the door movement.
During the closing stage, the encoder reverses door motion until the door is completely reopened.
The board also has a motor torque adjustment electronic system which, according to the setting, limits door thrust,
respecting current legal regulations.
• Encoder intervention DOES NOT DISABLE automatic re-closing.
•
The electronic clutch must be adjusted in conformity with current safety regulations.