FAAC E550, Manual

Page: 6 / 12

5
ENGLISH
BASIC PROGRAMMING
Display Function dF01
dF
DEFAULT PROGRAMMING:
00
Neutral condition.
0 1
Default
01
loaded
02
Default
02
not used
03
Default
03
not used
04
Default
04
not used
If you do not wish to load or modify a default, leave
dF
on value
00
.
00
LO
FUNCTION LOGICS:
E
Semi-automatic
EP
Semi-automatic “Step-by-step”
A
Automatic
AP
Automatic “Step-by-step”
E
PA
PAUSE TIME:
This operates only if an automatic logic was selected. Can be adjusted from
0
to
59
sec in one second
steps.
Next, the viewing changes in minutes and tenths of a second (separated by a dot) and time is adjusted in 10
second steps, up to the maximum value of
4.1
minutes.
ES: if the display shows
2.5
, the pause time will be 2 min and 50 sec.
2.0
In
To exit programming and return to display of inputs status.
(see chapter 6)
7.1 BASIC PROGRAMMING
To access BASIC PROGRAMMING, use push-button F :
• if you press it (and hold it down), the display shows the name of the first function.
• if you release the push-button, the display shows the value of the function, which can be changed with keys + and - .
• if you press F again (and hold it down), the display shows the name of the next function.
• when you reach the last function, press the F push-button to exit programming, and the display resumes showing
the inputs status.
The following table (Tab.2) indicates the sequence of functions accessible in BASIC PROGRAMMING:
Tab. 2
7.3 ROTATION DIRECTION CHECK
Procedure for checking exact connection of motor phases:
1) Put the operator in manual mode.
2) Manually take the door to its opening mid-point.
3) Lock the operator.
4) Power up the system.
5) Send an opening pulse ( OPEN ) and check if the motor executes a door opening operation. If the door closes, change
over the phases of the electric motor on the terminal-board (black and brown cables) of the board.
For two-operator applications: assign the same wire colours to the “ COM,OP,CL ” terminals of the E550 board and of the
SLAVE board, and, if you have to change over the phases, change them over for both motors.
• The board carries out an electronic control (the connected motor must be present) before every start. If you
attempt to make the board operate without motor load or with an insufficient load, no power is supplied at
motor output.
• The courtesy light lights up when the motor starts and remains lighted for the programmed time, starting when
the movement has finished.
7.2 ADJUSTMENT OF OPENING AND CLOSING LIMIT SWITCHES
1) Release the operator.
2) Open the door to the required point; adjust the cam until the FCA micro push-button is activated.
3) Tighten the screw on the cam.
4) Close the door to the required point; adjust the cam until the FCC micro push-button is activated.
5) Tighten the screw on the cam.
6) Relock the operator.