2 4
E124 34
532365 - Rev.A
8
.
8
.
OPEN B
CLOSE
BUS 2easy
OPEN A
STOP
OPEN A
BUS 2easy
88
88.
88
88
.
no
no
.
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
Opening and closing photocells
Photocells for OPEN A
Closing sensitive edge
Not used
Opening sensitive
edge
Opening photocells
Closing photocells
FIRMWARE VERSION (FW)
The FW version of the board (e.g.
4.0
) is shown on the
display for 1 s each time it is switched on, after which
the automation status is shown.
STATUS OF THE AUTOMATION
The automation status is shown by a code on the
display, when the board is not in the programming
menus (
Automated system status).
CHECKING THE MOVEMENT
Access basic programming and use function
M2
for
Leaf2 (displayed if the automation is configured for 2
leaves) and function
M1
for Leaf1.
1. The function displays
--
.
2. Use buttons
++
and
--
in dead man mode. One of
the expected commands must be given:
++
to OPEN (
oP
on the display)
--
to CLOSE (
cL
on the display)
Otherwise, temporarily disconnect the power supply
and invert the polarity of the motor connection.
IMPORTANT
If the automation has 2 leaves, end the test with the
leaves positioned so there is no interference between them.
BUS 2EASY STATUS
To check the BUS 2easy connection, look at the 2EASY
LEDs on the board.
RED
(DL12)
At least one device is in operation
NO devices in operation
GREEN
(DL 13)
OK
SLEEPING
SHORT CIRCUIT
ERROR
The status of the BUS 2easy is also shown in the
bu
function in Basic Programming (
WARNINGS FROM A PROGRAMMABLE OUTPUT
The available warnings can be enabled via program-
mable outputs (OUT1, OUT2) (see advanced program-
ming, functions
o1
,
o2
).
Closing photocells
BUS 2easy status
Basic Programming, function
bu
displays the status:
Encoder 2
no
= no device registered
Segment BUS 2easy = at least 1 device
registered. Press
++
: the segments of the
types of devices registered light up
E.g.: 1 or more OPEN A control devices and closing photocells
are registered:
Encoder 1
7
Automated system status
00
Closed
07
Failsafe in progress
01
Open
08
BUS 2easy device verification
in progress
02
Stationary then opens
09
Pre-flashing and then opens
03
Stationary then closes
10
Pre-flashing and then closes
04
In pause mode
11
Opening in Emergency
05
Opening
12
Emergency close
06
Closing
13
Hold Position
Summary of Contents for E124
Page 1: ...E124 Translation of the original instructions...
Page 43: ......
