15
ENGLISH
ENGLISH
11.
INSTALLATION OF HOUSING FIXING BRACKETS
•Fit a housing fixing bracket at the end of the head profile,
opposite the motor unit, using the supplied screws and plates
(fig.23).
•Fit the second housing fixing bracket slightly off-centre of the
head profile, to enable you to make the door-centre
adjustments.
•Secure the bracket supporting the internal release knob to
the other end of the head profile (on the motor unit side), as
shown in fig. 24.
The support bracket of the internal release knob must always
be installed, even if the motor lock is not used.
Fig. 23
Fig. 24
12.
MOTOR LOCK
The motor lock is a device guaranteeing the leaves are
locked when closed.Installation procedure:
•Secure the motor lock with the two supplied bolts as shown
in fig. 25 ref.
.
•Manually push the lever (fig. 26 ref.
) toward the motor
shaft, checking for correct meshing as per fig. 26 ref. A.
•Move the lever (fig. 26 ref.
) vertically and check if there is
play between the motor-shaft and motor-lock coupling.
Fig. 25
Fig. 22
Fig. 26
A
B
If there is no play on the coupling, proceed as follows:
•Loosen the two screws (fig. 27 ref.
) on both carriages.
•Slightly move the belt horizontally until the lever moves
smoothly; tighten the screws on the carriages.