SETTING
+
J24
DL19 DL20 DL21 DL22
DL14 DL15 DL16 DL17 DL18
Main power supply
115 V~ 60 Hz
Secondary power
supply
24 Vdc - 16 A max.
(min. 20 Vdc. - max. 36 Vdc.)
Power consumption
stand-by = 4W max. = 400 W
Max load per motor
7 A
Accessory power
24 Vdc - 500 mA
Battery charge current
150 mA
Operating temperature
-4 °F +131 °F (-20 °C +55 °C)
Protection fuses
All self-resetting
Main power fuse
6.3 A Timed
Operating Logics
E, A, S, EP, AP, SP, B, C
Operating time out
10 min.
Pause time
Programmable (0 to 4 min)
Motor force, speed, ob-
stacle sensitivity, closing
delay
Programmable with
dedicated trimmer
Connector inputs
Power supply, Battery,
Radio receiver, USB
Terminal strip inputs
Encoder, Open A, Open B, Stop,
Open safety photocell, Closing
safety photocell, Limit switches
Terminal strip outputs
Audio Alarm, Lock, Motors,
Accessory power supply
Programming
With trimmers, dipswitches
and pushbutton
RADIO
Connector for the radio receiver
BATTERY
Connector for the backup battery
J24
Jumper to disable battery charging
(With the jumper present the battery
charger is enabled)
POWER SUPPLY
DC Power supply input
TR1 to TR6
Programming Trimmers
+24 LED
DC power indicator
SW1 - SETUP
Pushbutton for automatic setup
DS1 - DS2
Programming dipswitches
LED ERROR
Troubleshooting indicator
USB A
USB connection for software upgrade
On the radio connector it’s possible to plug in receivers RP
and RP2. With a single channel radio RP it will be possible to
activate only the OPEN A input, with a dual channel radio RP2
it will be possible to activate both OPEN A and OPEN B inputs.
Plug in the radio board with the component side towards the
internal part of the board.
Make sure you insert or disconnect the board
ONLY with the power off.
1.1 TECHNICAL SPECIFICATIONS
1.2 LAYOUT AND COMPONENTS
1.3 RADIO CONNECTION
Fig. A1
1. E024U CONTROL BOARD DESCRIPTION & CHARACTERISTICS
This manual refers to board version
1D
12