8
Fig. 10a
Fig. 11
Fig. 10b
Fig. 13
Fig. 12
2.4 Installing the operator
1. Open the gate leaf.
2. Place the operator on the fastening bolts on the foun-
dation box, and secure it using the supplied nuts and
washers (Fig. 13).
Note
: the exact position of the operator is shown in Fig. 12. In
any case, the operator pinion must be on the opposite side
of leaves opening direction.
3. Manually close the leaf and assemble the supplied driv-
ing levers, as shown in Fig. 13.
Note
: grease the operator pinion and the pivots of the two
levers.
4. Install the second operator, if required, by repeating the
operations described above.
5. Install the electronic control unit. Refer to the relative
instructions.
6. Fasten the box cover using the supplied screws (Fig. 14)
.
• Determine the correct location of the leaf on the “U” profile
with reference to the axis of rotation (Fig. 10a and 10b);
• Close the “U” profile on the post side with a small plate, as
shown in Figs. 10a and 10b.
3. Carefully weld the guide bracket to the support bracket
(Fig. 11).
4. Fit the gate into the guide bracket and fix the top hinge
in place.
IMPORTANT
: To ensure trouble-free operation, do NOT weld
the gate leaf to the guide bracket or to the support bracket.
5. Manually verify whether the gate opens and closes com-
pletely and smoothly, stopping at the mechanical travel
stops.
