EZAutomation EZ 10 Series, Getting Started Manual, Page: 14 / 69

8 | P a g e
EZ12 Mounting
All EZ12 panels have a new innovative mounting design. This design allows the unit to not need any
external mounting components. The mounting brackets and screws are already included in the unit. Also
the unit is designed to be very easy and simple to mount. No more trying to figure out which way to
attach DIN clips and no more looking for screws and nuts. This design has also been used in all sizes of
EZ12 units to make the design consistent and making mounting simple and easy no matter which size
panel you have.
NOTE: The maximum torque force that should be applied is 2 ½ to 3 inch-pounds.
Mounting directions:
1. When looking at the back of the unit please look at the screws in the corners of the unit. These
screws are screwed into the flip out din brackets (retainers) for the panel.
2. Unscrew the screws and you can flip out the din brackets. The 6” and 7” units have 4 (1 in each
corner), the 8” has 5 (1 in each corner and 1 at the top midpoint), and the 10” unit has 6 (1 in
each corner and 1 at the midpoint at top/bottom).
3. Then use the screws and the din brackets to mount the panel. The maximum torque force that
should be applied is 2 ½ to 3 inch-pounds.
1
2
3
4
6”/7” Inch 8” Inch 10” Inch
1
2
3
4
5
1
2
3
4
5
6