For more information call 1-800-654-8168 or go to www.ez-dock.com.
20
Keel Roller Adjustment for EZ Port MAX
The EZ Port MAX comes from the factory with one adjustable roller. The roller is factory installed in Position 2. It may be
necessary to adjust the roller on your new EZ Port MAX. Your EZ Port MAX can be adjusted to fit most personal watercraft
(PWC). The roller can be placed in any one of four positions. The illustrations below show each of the four positions. A
roller placed too high or too low may cause difficulty in docking and launching your PWC. This process may take several
adjustments before getting the correct position for your PWC model. Your EZ Port MAX is designed to make launching and
docking fast, fun, and easy.
Position 1
A. Axle plate up.
B. Spacers above plate.
Position 2 (Default)
A. Axle plate up.
B. Spacers below plate.
Position 3
A. Axle plate down.
B. Spacers above plate.
Position 4
A. Axle plate down.
B. Spacers below plate.
Tools required:
Phillips Screwdriver
•
Procedure:
Loosen 4 screws, (Item 3), and remove.
For Position 1, remove roller (Item 4) and spacers (Item 2).
Replace roller as shown in illustration above. Place
spacers on top of axle plate as shown. Install screws and
tighten.
For Position 3, remove roller (Item 4) and spacers (Item 2).
Replace roller as shown in illustration above. Place
spacers on top of axle plate as shown. Install screws and
tighten.
For Position 4, remove roller (Item 4). Replace roller as
shown in illustration above with spacers (Item 2) below
plate. Install screws and tighten.
BILL OF MATERIAL
ITEM
QTY.
PART NO.
DESCRIPTION
1
4
80575SS
Bolt 5/16”-18 x 3/4” Truss HD 18-8 SS
2
4
S32050
Spacer 1” OD x 3/8” ID Black Polyethylene
3
4
80514SS
Bolt 5/16”-18 x 1 1/4” Truss HD 18-8 SS
4
2
M25012
Keel Roller Assembly 12”
3
1
4
2
